Aladdin-light-lift ALL300-CM Manual do Utilizador

ALL300 INSTALLATION INSTRUCTIONSAladdin Light Lift, Inc. (256) 429-970061 Shields Road (877) 287-4601Huntsville, AL 35811 www.aladdi

STEP 23Adjust canopy and telescopic conduit assembly so contact plates meet before the canopy touches the ceiling. See Diagram I.Never allow the chan

STEP 27Tighten xture coupler set screws using supplied 3/32” Allen wrench. Fixture coupler set screws have thread lock already applied at factory. S

ALL300 TROUBLESHOOTING GUIDETECH SUPPORT: (877) 287-4601 Monday through Friday 8:00am to 4:00pm CSTI. Troubleshooting and installation must be perfor

ALL300 TROUBLESHOOTING GUIDE cont. 1. Conrm ALL300 is at the CEILING POSITION. If not, use the controller to operate the ALL300 to the CEILING POSI

Warranty AgreementAladdin Light Lift, Inc. warrants its chandelier light lift unit for one year from the date of purchase. e warranty includes all p

Read the following guidelines prior to installing the ALL300:I. e ALL300 must be installed by a licensed, bonded and insured electrician. II. e ALL

STEP 1Determine where ALL300 will mount on ceiling joists. ALL300 must be installed level, in an accessible location directly above chandelier.Never

STEP 5Attach the 1/2” conduit connector on ceiling box to bottom of conduit assembly. Once completely inserted, tighten set screw on conduit connecto

STEP 7Position ALL300 where ceiling box will be centered in ceiling hole. Weight and bottom contact plate assembly should hang down through ceiling h

STEP 9Shim and adjust ALL300 so that winch cable hangs plumb through center of hole in top contact plate on ceiling box. See Diagram E. Look up at c

STEP 11Turn o supply power before wiring ALL300. Turn o motor switch in square box. Wire motor switch with 110V wiring. e 110V motor feed must be

STEP 13Remove dust cover and remove paper tape from winch drum while keeping tension on winch cable.Never operate the ALL300 without tension on the ca

STEP 20Fully thread screw collar loop or threaded stem that was supplied with chandelier to 1/4 IPS xture coupler. If chandelier was supplied with a